AbstractTorsional creep tests were conducted on Inconel 718 specimens under 17 MeV proton irradiation at 300°C for doses up to ∼0.08 dpa. The stress dependence of the irradiation creep rate was measured by increasing the maximum applied shear stress from 150 up to 450 MPa. The experimental results show that the stress dependence of the irradiation creep rate is linear in the whole stress range applied. The irradiation creep constant κ=1.2×10−11 (dpa−1 Pa−1) at 300°C. The calculated creep induced stress relaxation amounts to ∼10% after 0.1 dpa. The results are discussed in relation to the operating condition of an ITER-like machine, where Inconel 718 bolts are used to mechanically attach the shielding blanket to the back plate.
インコネル718試験片に対し、300°C、最大約0.08 dpaの線量までの17 MeV陽子照射下でねじりクリープ試験を実施した。照射クリープ速度の応力依存性は、最大せん断応力を150 MPaから450 MPaまで増加させることにより測定した。実験結果は、照射クリープ速度の応力依存性が、適用した全応力範囲において線形であることを示している。300°Cにおける照射クリープ定数κは1.2×10−11 (dpa−1 Pa−1)である。計算されたクリープ誘起応力緩和は、0.1 dpa後に約10%となる。この結果は、遮蔽ブランケットを背面板に取り付けるためにインコネル718ボルトが使用されるITER類似装置の運転条件に関連して考察される。