The large-aspect-ratio model for current-driven external kinks is applied to study control of non-axisymmetric resistive wall modes in tokamaks. Comparison with toroidal computations indicates that the cylindrical instabilities react in similar ways to feedback as the pressure-driven toroidal modes, when the feedback and sensor coils are placed on the low-field side of the torus. However, higher gain is required in the cylindrical case. The cylindrical model is used to gain insights into design issues concerning a feedback system for ITER, with a double wall and superconducting coils. Good control performance and acceptable coilvoltages are found in an initial value problem, where the initial conditions correspond to expected noise levels, when sensors for the poloidal field are placed inside the first wall. This can be accomplished with a PI (proportional plus integral) controller from the voltages of the sensor loops to the voltage over the active coils. The two-wall structure of ITER makes control somewhat more demanding than for tokamaks with a single wall. Adequate control can be achieved also when poloidal sensors are placed outside a single wall, but this requires additional derivative action (PID) and the resulting voltages are significantly higher.