Experiments on a non-disruptive halo-current influence on the m = 2 mode behaviour at the flat-top stage of a tokamak discharge are presented. The halo-current in the rail limiter—plasma—vacuum vessel—external circuit—rail limiter loop was used. An EMF source controlled with a preprogrammed signal or with a feedback m = 2 signal was introduced into the external part of the halo-current circuit. The EMF source has generated the oscillating halo-currents with an amplitude of up to 500 A in the frequency range 0–20 kHz. In the case of the preprogrammed control signal the switching on of the EMF source resulted in the shift of the m = 2 mode frequency to the frequency of the halo-current oscillations. In particular, the rotation of the m = 2 mode stopped under a pulse of zero-frequency halo-current. In the tokamak discharges, when the mode rotation spontaneously stopped before the switching on of the oscillating halo-current, the mode rotation was restored at the halo-current frequency. In the case of the halo-current feedback control by the m = 2 mode signal, the effect depended on the choice of the phase shift in the feedback loop. Some increase or decrease of the m = 2 mode amplitude as well as some variations of the mode frequency were observed at different values of the phase shift. The halo-current effect on the m = 2 mode behaviour can be attributed to a coupling between the m/n = 2/1 magnetic islands and the halo-current magnetic field. The experiment was simulated on the assumption that the tearing mode is affected by the halo-current magnetic field component with the same helicity. In the calculations for the T-10 conditions, the mode behaviour under the effect of the halo-current was similar to the experimental observations.
トカマク放電のフラットトップ段階におけるm=2モードへの非破壊的ハロー電流の影響に関する実験を提示する。レールリミター—プラズマ—真空容器—外部回路—レールリミターのループにおけるハロー電流を用いた。外部ハロー電流回路には、プリプログラムされた信号またはフィードバックm=2信号によって制御されるEMF源を導入した。EMF源は、0〜20 kHzの周波数範囲で最大500 Aの振幅を持つハロー電流振動を生成した。プリプログラムされた制御信号の場合、EMF源の投入によりm=2モード周波数がハロー電流振動周波数へシフトした。特に、ゼロ周波数のハロー電流パルスによりm=2モードの回転が停止した。トカマク放電において、ハロー電流振動の投入前にモード回転が自発的に停止した場合、モード回転はハロー電流周波数で回復した。m=2モード信号によるハロー電流フィードバック制御の場合、その効果はフィードバックループの位相シフトの選択に依存した。位相シフトの異なる値において、m=2モード振幅の増減およびモード周波数の変動が観測された。m=2モード挙動へのハロー電流効果は、m/n=2/1磁気島とハロー電流磁場との間の結合に帰属できる。この実験は、テアリングモードが同じヘリシティを持つハロー電流磁場成分の影響を受けるという仮定に基づいてシミュレーションされた。T-10条件の計算において、ハロー電流効果下でのモード挙動は実験観測と類似していた。