FusionPapers
図版検索トレンドwiki日本の研究
© 2026 FUSIONPAPERS
About法務情報
トップに戻る

First campaign with alternative divertor configurations in ASDEX Upgrade

T. Lunt, F. Albrecht, M. Bernert, D. Brida, R. Dux, M. Faitsch, T. Gleiter, S. Hörmann, J. Kalis, B. Kurzan2026年10月Nuclear FusionIF 3出版社

After a major hardware extension ASDEX Upgrade has now established and characterized a variety of alternative divertor configurations (ADCs) with heating powers reaching up to 20 MW and plasma currents up to 1 MA. These high performance conditions in configurations with arbitrarily small field line incidence angles were made possible due to the high precision in the tile alignment of 300 m as well as a careful optimization of the error fields caused by the current feeds. The formation of an X-point radiator (XPR) was observed in a low-field-side snowflake minus (LFS SF) configuration at a very low impurity concentration determined by the intrinsic sources only, i.e. without additional seeding of impurities. Compared to a typical lower single-null (SN) configuration the edge localized modes (ELMs) were found to be substantially smaller in size and higher in frequency and therefore barely detectable. While the primary strike line is fully detached the secondary one in the far-SOL shows heat fluxes of a similar magnitude as the primary strike line in a previous upper SN phase. These fluxes might be reduced by installing configuration-optimized baffles and/or by increasing the plasma current and thereby reducing . In fact significantly smaller far-SOL heat fluxes were found when increasing the plasma current from 800 to 1000 kA. According to the divertor Langmuir probes the peak heat flux is then by a factor of two smaller than the ones in the SN reference.

日本語訳

主要なハードウェア拡張の後、ASDEX Upgradeは現在、最大20 MWの加熱電力と最大1 MAのプラズマ電流に達する、多様な代替ダイバータ配位(ADC)を確立し、特性評価を行った。任意に小さな磁力線入射角を持つ配位におけるこれらの高性能条件は、300 mのタイル整列における高精度と、電流供給によって引き起こされる誤差磁場の慎重な最適化によって可能となった。X点放射体(XPR)の形成は、低磁場側スノーフレークマイナス(LFS SF)配位において、追加の不純物シーディングなしで、すなわち内在源のみによって決定される非常に低い不純物濃度で観測された。典型的な下部シングルヌル(SN)配位と比較して、周辺局在モード(ELM)はサイズが大幅に小さく、周波数が高く、そのためほとんど検出できないことが見出された。一次ストライクラインが完全にデタッチしている一方で、遠スクレイプオフ層(far-SOL)の二次ストライクラインは、以前の上部SNフェーズにおける一次ストライクラインと同程度の大きさの熱流束を示す。これらの熱流束は、配位最適化されたバッフルの設置および/またはプラズマ電流の増加による低減によって低減される可能性がある。実際、プラズマ電流を800 kAから1000 kAに増加させると、遠SOL熱流束が大幅に小さくなることが見出された。ダイバータラングミュアプローブによると、ピーク熱流束はその場合、SN参照のものより2倍小さい。

装置

asdex-upgrade高精度(タイトル一致)

wiki

DivertorASDEXASDEX Upgrade

AIによる論文要約

ASDEX Upgradeにおける代替ダイバータ配位の初回キャンペーン
JA核融合プラズマ・ダイバータ研究の学生や若手研究者、ADCと熱負荷低減に関心のある技術者#核融合 #ダイバータ #ASDEXUpgrade #プラズマ #熱負荷
LLM向け: {"Title": "ASDEX Upgradeにおける代替ダイバータ配位の初回実験キャンペーン", "Authors": "不明(提供された情報に記載なし)"…

ASDEX Upgradeは大規模改造後、最大20 MW加熱・1 MA電流で多様な代替ダイバータ配位(ADC)を確立・特性評価した。高精度なタイル整列と電流フィード起因の誤差磁場最適化により、磁力線入射角が極めて小さい配位でも高性能を実現。低磁場側スノーフレークマイナスでは不純物添加なしでもX点放射体が形成された。ELMは標準SNより小さく高頻度でほとんど検出されず、主ストライク線は完全非接触。遠SOL熱流はバッフル最適化や電流増加で低減でき、1000 kAではピーク熱流束がSN参照の約半分となった。

関連論文

Dependence of turbulent transport on the divertor flux expansion in ASDEX Upgrade

2026Nuclear Fusion

SOLPS simulations of detachment in a snowflake configuration for the future upper divertor in ASDEX Upgrade

2018Plasma Physics and Controlled Fusion

Simulations on the transient heat fluxes for the low-hybrid wave heating H-mode on EAST

2019Nuclear Fusion

Evaluation of SPARC divertor conditions in H-mode operation using SOLPS-ITER

2024Nuclear Fusion

Impact of divertor geometry on radiative divertor performance in JET H-mode plasmas

2016Plasma Physics and Controlled Fusion

Investigation of conventional and Super-X divertor configurations of MAST Upgrade using scrape-off layer plasma simulation

2014Plasma Physics and Controlled Fusion

Role of electric currents for the SOL and divertor target heat fluxes in ASDEX Upgrade

2020Plasma Physics and Controlled Fusion

Divertor heat flux mitigation in high-performance H-mode discharges in the National Spherical Torus Experiment

2009Nuclear Fusion

Heat flux pattern in detached L-modes and ELM mitigated H-modes with rotating magnetic perturbations in ASDEX Upgrade

2017Nuclear Fusion

Survey of target plate heat flux in diverted DIII-D tokamak discharges

1998Nuclear Fusion