AbstractExperimental investigations are presented, where a device similar to a plasma thruster using j×B forces has been used, to accumulate and accelerate a plasma with a mass of about 0.2 mg to beam velocities up to 110 km/s. A pulse line with a capacity of 108 μF was used to provide discharge currents up to 450 kA for a pulse length of 6.5 μs. The discharge vessel consists of a set of coaxial electrodes with a diameter of 5 cm at a length of 50 cm. The total energy efficiency of the plasma acceleration from this process is estimated to be better than 10%. An estimate of the mass of the plasma beam was achieved by measuring the momentum transfer from plasma beam to flyer plates. Using conus-shaped electrodes at the exit of the plasma accelerator a focusing of the plasma to a diameter below 1 cm was achieved.
プラズマ加速器の出口に円錐形電極を用いることにより、プラズマを1cm以下の直径に集束させることが達成された。j×B力を利用するプラズマスラスタに類似した装置を用いて、約0.2mgの質量を持つプラズマを蓄積し、最大110km/sのビーム速度まで加速する実験的調査が提示されている。容量108μFのパルスラインを用いて、パルス長6.5μsの間に最大450kAの放電電流を供給した。放電容器は、直径5cm、長さ50cmの同軸電極対から構成される。このプロセスにおけるプラズマ加速の総合エネルギー効率は10%以上と推定される。プラズマビームの質量の推定は、フライヤープレートへの運動量伝達を測定することによって達成された。