A carbon film resistance probe was used to measure the energy and flux of energetic neutral deuterium in the pumping duct of the pumped limiter on the PLT tokamak. The particle flux at the back of the pumping duct increased from about 1012 to 4 × 1013 cm−2·s−1 as the limiter was moved into the plasma edge. With the limiter in the plasma edge, the mean particle energy measured at the back of the pumping duct was 160–300 eV. Gas pressures in the pumping duct up to about 1 mtorr were measured but were found to have little effect on the energetic neutrals reaching the back of the pumping duct. Particle transport calculations indicate that pressures more than an order of magnitude higher than observed would be necessary to stop the particles. The measured flux of energetic neutrals is estimated to be large enough to contribute significantly to the particle removal rate achieved by the pumped limiter.
炭素膜抵抗プローブを用いて、PLTトカマクのポンプリミターにおけるポンピングダクト内の高エネルギー中性重水素のエネルギーとフラックスを測定した。リミターをプラズマ端へ移動させると、ポンピングダクト背面での粒子フラックスは約10¹²から4×10¹³ cm⁻²·s⁻¹まで増加した。リミターがプラズマ端にある場合、ポンピングダクト背面で測定された平均粒子エネルギーは160〜300 eVであった。ポンピングダクト内のガス圧は約1 mtorrまで測定されたが、ダクト背面に到達する高エネルギー中性粒子にはほとんど影響を及ぼさなかった。粒子輸送計算によれば、粒子を停止させるには観測された値より一桁以上高い圧力が必要であることが示された。測定された高エネルギー中性粒子のフラックスは、ポンプリミターによって達成される粒子除去率に有意に寄与するのに十分な大きさであると推定される。