図版検索トレンド wiki 日本の研究

© 2026 FUSIONPAPERS

About 法務情報

トップに戻る

Additive manufacturing of ITER first wall panel parts by two approaches: Selective laser melting and electron beam melting

Yuan Zhong, Lars-Erik Rännar, Stefan Wikman, Andrey Koptyug, Zhijian Shen2017年Fusion Engineering and DesignIF 1.7 出版社

装置

iter高精度(タイトル一致)

wiki

ITER Electron beams First wall

この論文にはまだAI要約がありません。

関連論文

Fabrication of HCPB breeding blanket components using the additive manufacturing processes of selective laser melting and cold spray

2020Fusion Engineering and Design

Melting and conduction during short electron beam pulses

1990Fusion Engineering and Design

Two-dimensional numerical simulation of tungsten melting in exposure to pulsed electron beam

2018Fusion Engineering and Design

Fabrication of thin-walled fusion blanket components like flow channel inserts by selective laser melting

2019Fusion Engineering and Design

Advances in Additive Manufacturing of fusion materials

2021Fusion Engineering and Design

Removal of the plasma contained in an atomic beam produced by electron beam heating

1994Review of Scientific Instruments

Manipulation and electron-oscillation-measurement of laser accelerated electron beams

2011Plasma Physics and Controlled Fusion

Effect of laser beam filamentation on plasma wave localization and electron heating

2007Physics of Plasmas

Optimization of beam configuration in laser fusion based on the laser beam pattern

2013Physics of Plasmas

First results of LHW-generated fast electron-induced melting of TZM limiter in EAST

2026Nuclear Fusion