AbstractA flat carbon fiber composite (CFC) tile mock-up with screw tubes, which have helical fins like a nut, was fabricated aiming at further improvement of the heat removal performance of the cost-effectively manufactured divert or target for JT-60SC (modified JT-60 as a superconducting coil tokamak). The heat removal performance of the mock-up was successfully demonstrated on the JAERI Electron Beam Irradiation Stand. The estimated heat transfer coefficient of the screw tube at the non-boiling region was roughly three times higher than that of the smooth tube. This corresponds to 1.5 times that of the swirl tube. A heat cycle test of 10 MW/m2 showed that the mock-up with the screw tubes could withstand for 1400-cycles. These results indicate that the divertor target plate with the flat CFC tile and the screw tube can be a promising candidate for the JT-60SC divertor target.
Divertor development for ITER