An infrared camera has been used to check the power balance calculations in a series of JET divertor discharges. The discharges spanned the density range (ne)=(1-7)*1019 m-3, with the highest densities achieved by neutral beam heating and intensive gas puffing. For the discharges in which IR data were taken, the total power to the target, as deduced from the IR signal, was proportional to the expected divertor target power estimated from Pin-Prad-W, where Pin is the input power to the plasma, Prad the measured radiated power, and W the rate of change in the plasma stored energy. Close proportionality, pointing to good power balance, has been achieved in ohmic plasmas, as well as in L- and H-modes with either RF and/or NB heating up to 22 MW, of which up to 12 MW was monitored on the target as heat deposition by the IR system. Analysis of the data has shown no systematic trends of deteriorating power balance with increasing volume-averaged density or with heating power.
赤外線カメラを用いて、一連のJETダイバータ放電におけるパワーバランス計算を検証した。これらの放電は密度範囲(ne)=(1-7)×10^19 m^-3にわたり、最高密度は中性粒子ビーム加熱と強力なガスパフによって達成された。IRデータが取得された放電において、IR信号から導出されたターゲットへの全パワーは、P_in-P_rad-Wから推定されるダイバータターゲットへの期待パワーに比例した。ここで、P_inはプラズマへの入力パワー、P_radは測定された放射パワー、Wはプラズマ蓄積エネルギーの時間変化率である。この密接な比例関係は、パワーバランスが良好であることを示しており、オーミック放電、ならびにRFおよび/またはNB加熱によるLモードおよびHモード放電のいずれにおいても達成された。加熱パワーは最大22 MWであり、そのうち最大12 MWがIRシステムによってターゲットへの熱堆積として監視された。データ解析の結果、体積平均密度または加熱パワーの増加に伴うパワーバランスの悪化に関する系統的な傾向は見られなかった。