FusionPapers
図版検索トレンドwiki日本の研究
© 2026 FUSIONPAPERS
About法務情報
トップに戻る

Intrinsic molybdenum impurity density and radiative power losses with their scalings in ohmically and ICRF heated Alcator C-Mod and FTU tokamak plasmas

M J May, K B Fournier, J A Goetz, J L Terry, D Pacella, M Finkenthal, E S Marmar, W H Goldstein1999年Plasma Physics and Controlled FusionIF 2.2出版社

A new radiative cooling curve for molybdenum, determined from the Hebrew University, Jerusalem - Lawrence Livermore atomic code (HULLAC) has been used to estimate the radiative power losses from various ion cyclotron resonance frequency (ICRF) and ohmically heated Alcator C-Mod tokamak plasmas and ohmically heated Frascati tokamak upgrade (FTU) plasmas. This cooling curve has been found to accurately predict the radiative losses from molybdenum ions in plasma. Radiative losses from molybdenum computed by using the HULLAC cooling curve could typically account for greater than 60% of the total radiative losses as measured by bolometry in Alcator C-Mod tokamak plasmas. The molybdenum density was found to be as high as particles in ICRF heated plasmas. Plasmas after botonization of the plasma facing surfaces had the lowest molybdenum density and radiated power of all the plasmas examined; ICRF heated plasmas had the highest. The molybdenum density and radiative power losses were found to increase roughly linearly with input ICRF power during different heating schemes in plasmas with both H-mode and L-mode confinement. Although the molybdenum densities were found to decrease with increasing electron density, the radiative power losses did not change significantly for all types of plasmas studied in Alcator C-Mod and FTU: diverted plasmas heated with ICRF and both limited and diverted plasmas heated ohmically.

日本語訳

ヘブライ大学エルサレム校-ローレンスリバモア原子コード(HULLAC)から決定されたモリブデンの新しい放射冷却曲線を用いて、様々なイオンサイクロトロン共鳴周波数(ICRF)加熱およびオーミック加熱されたAlcator C-Modトカマクプラズマ、ならびにオーミック加熱されたFrascatiトカマクアップグレード(FTU)プラズマからの放射損失を推定した。この冷却曲線は、プラズマ中のモリブデンイオンからの放射損失を正確に予測することが判明した。HULLAC冷却曲線を用いて計算されたモリブデンからの放射損失は、Alcator C-Modトカマクプラズマにおいてボロメトリで測定された全放射損失の60%以上を占める可能性があることが判明した。モリブデン密度は、ICRF加熱プラズマにおいて最大で 個/m³ に達することが判明した。プラズマ対向面のホウ素化後のプラズマは、調査した全プラズマの中で最も低いモリブデン密度と放射出力を示した。一方、ICRF加熱プラズマが最も高い値を示した。モリブデン密度と放射損失は、HモードおよびLモード閉じ込めの両方における異なる加熱方式において、入力ICRF出力とともにほぼ線形に増加することが判明した。モリブデン密度は電子密度の増加とともに減少することが判明したが、放射損失はAlcator C-ModおよびFTUで調査した全タイプのプラズマ、すなわちICRF加熱されたダイバータ配位プラズマ、ならびにオーミック加熱されたリミター配位およびダイバータ配位プラズマにおいて、有意な変化を示さなかった。

装置

alcator-c-mod高精度(タイトル一致)

wiki

ImpurityIon cyclotron heatingAlcatorC-ModOhmic heatingFTU
この論文にはまだAI要約がありません。

関連論文

Molybdenum density scaling in Alcator C-Mod L- and I-mode plasmas

2026Nuclear Fusion

The measurement of the intrinsic impurities of molybdenum and carbon in the Alcator C-Mod tokamak plasma using low resolution spectroscopy

1997Nuclear Fusion

Internal transport barrier production and control in Alcator C-Mod

2004Plasma Physics and Controlled Fusion

ICRF plasma production at hydrogen minority regime in LHD

2023Nuclear Fusion

Molybdenum transport in high density FTU plasmas with strong radio frequency electron heating

2007Plasma Physics and Controlled Fusion

Rotation and transport in Alcator C-Mod ITB plasmas

2010Nuclear Fusion

The influence of plasma-edge properties on high confinement discharges with a radiating plasma mantle at the tokamak TEXTOR-94

1997Plasma Physics and Controlled Fusion

H mode confinement in Alcator C-Mod

1997Nuclear Fusion

Calculation of the radiative cooling coefficient for molybdenum in a low density plasma

1998Nuclear Fusion

Survey of ICRF heating experiments and enhanced performance modes in Alcator C-Mod

1996Plasma Physics and Controlled Fusion